Classic Moth Plans Mistral Hull Panel Offsetts

08.04 in Boat Plans, classic, hull, mistral, moth, offsetts, panel, plans

Despite being the tippiest Classic Moth design out there, more Mistral designs are built in the U.S than any other design - by a long shot. Although a competent Laser or Sunfish racer has no problem handling a Mistral (after an initial "lets get acquainted session" to get over the wobbliness) other, less experienced sailors, get sucked in by the simple stitch and glue, bend-em-up, building process. Sometimes they have been very surprised when they get on the water.

More information on the Mistral design can be found here.

The front end of a Mistral - this is Mike Parsons.

The back end of a Mistral - this is John Zs.

For those not to be dissuaded by my introductory warning and desire to build a Mistral, here are the Mistral panel offsets in both DXF and PDF formats.

(Note!: These offsets are only the beginning - you will need at least three bulkheads, a transom, and framing around the mast step to finish up the shape.)

The section dimensions of the fast Y2K Mistral can be found here.

A DXF drawing of the hull panel (you will need 2 identical panels to form a hull). Use the pop-out icon (top-right) to open in another tab to print or download.



A PDF file with the offsets. Use the pop-out icon (top-right) to open in another tab to print or download.



A short synopsis of Derek Chesters original instructions for the Mistral build. Again, use the pop-out icon (top-right) to open in another tab to print or download.