Today was a hodgepodge of activities. I began the morning lacing the leathers on the new oars I received recently. The lacing process was made more difficult by very confusing directions that came with the oar leather "kit". For instance, measuring distances from the "top" of the oar begs the question, "Which end is the top?" It is also unhelpful to say the seam should lie "parallel" to the blade, since a seam in any position around the 360 degrees of the loom (or shaft) of the oar could be said to be parallel. But finally, after cutting the leather to size, meticulously marking and punching holes, and laboriously stitching the leather around the oar, I was satisfied with the result. After about two hour work (which I wont count against the boat building total) I completed one oar.
I then went outside to enjoy another sunny warm midwinter day. Todays task was to trim the strakes at each transom. With careful use of a Japanese (flush cut) saw, and a belt sander with 80-grit paper, the strake overhangs were brought flush with the transoms. Further sanding with 120-grit paper in an orbital palm sander finished the ends nicely. There are a couple of small gaps between the strakes and the transoms that will need to be filled in with thickened epoxy. But all is ready for the next step; the glassing of the interior. Total hours 41.00.
0 komentar:
Posting Komentar